Kitchen Cabinet are large pieces of furniture at home, and each replacement requires a lot of effort. Therefore, I want to choose good quality cabinets, hoping to use them as long as possible. So what do I need to pay attention to when buying a kitchen cabinet ? We together look!
one :Edge banding of plates
The edge of high-quality cabinets is delicate, smooth, feels good, the sealing line is straight and smooth, and the joints are fine. Professional manufacturers use linear edge banding machines to complete the edge banding, decapitation, trimming, chamfering, polishing and other processes at one time. The glue is applied uniformly, and the pressure of the laminating and sealing is stable. The workstations on the assembly line work continuously, and the accuracy of the processing size can be adjusted to the most suitable position to ensure the most accurate size. The small factory applies glue with a brush, manually presses the edge banding, trims it with a knife, and polishes it with a manual polisher. Due to the uneven coating, the edge band produced is uneven, the line is undulating, and even the edge banding I feel slippery, because the pressure is not uniform in many places, it is easy to open the rubber in a short time. Once the edge is peeled off, water will swell and a lot of toxic gases such as formaldehyde will be released into the air. Harm to the human body.
Second : Punch
The current board furniture is assembled by looking at the three-in-one connector, which requires a lot of positioning connection holes in the board. The fit and accuracy of the empty space will affect the structural firmness of the cabinet box. Small factories use ** to drill holes. Due to different positioning standards and dimensional errors during positioning. As a result, the accuracy of the hole position matching is very large, and even the hole position may not match during the box assembly process. The size error of the combined box is relatively large, not a regular cube, but twisted.
Three : Conference Board
The cutting board is also called the opening of the board, which is the first process of cabinet production. The performance of the precision equipment is stable. The dimensional accuracy of the board is very high, the tolerance unit is in micrometers, and there is no chipping phenomenon on the board edge.
The small manual factory uses a small manual to open the data. Even a simple operation table is set up with woodworking materials. The size error of the board produced by this simple equipment is often greater than one millimeter, and the phenomenon of chipping often occurs, that is, the board substrate is exposed.
Four : Cardboard
The door panel is the face of the cabinet, as important as the face of a person. Each of them wants to choose a good-looking “face” for their cabinets. Of course, the deformed “face” is not among the choices. Due to improper treatment of the substrate and surface technology, the door panels produced by small factories are prone to moisture and deformation.
Five : Assembly effect of the entire cabinet
The small gaps in the cabinet should be even, and the door panels should be straight. Any dimensional error in the production process will be reflected in the door panel. The door panels produced by professional manufacturers are horizontal and vertical, and the gaps between the doors are uniform. For the combined cabinets produced by small factories, the door panels will have uneven door gaps, uneven gaps, and large There are small, door panels not on a flat surface.
six : Slider of drawer
Although it is a small detail, it is an important part that affects the quality of the cabinet. Due to the gap between the vacancy and the size of the board, there is an error in the installation dimensions of the slide rail. Causes the drawer not to move smoothly or loosely. Also pay attention to whether the drawer gap is even.
